Vinyl sticker application

Before applying your Vinyl Lettering or Graphics thoroughly clean and dry the area first ________________________________________Position the lettering in the desired place and secure temporarily with a high tack masking tape as shown opposite ________________________________________Apply masking tape along the top edge of the lettering or graphics and the surface its being applied to thus creating a hinge ________________________________________When dealing with large letters or long lengths of lettering cut in between each individual letter first as shown opposite ________________________________________Lift up the vinyl on its hinge and completely remove the backing paper as shown opposite and put this to one side for later ________________________________________Slowly and carefully allow your vinyl to come back down and make contact with the surface its being applied to ________________________________________Using a squeegee with a firm pressure start at the top center, work downwards and outwards when applying the letteringto the surface ________________________________________Start removing the application tape at onecorner and slowly draw it back on it self at 180 degrees as shown opposite ________________________________________To ensure the vinyl is firmly attached cover it with the backing paper, the shinny side facing the vinyl, and squeegee again. Any air bubbles pop them with a pin and squeegee again.